Brush-making equipment hair transplanting machine is an equipment in many brush-making factories. There are many processing methods, such as mechanical/semi-automatic/fully automatic. Today, the editor of Meixin high-speed broom machine will introduce several processing methods of hair transplanting machine.
Mechanical
It is to continuously process products without stopping in the middle, unless the "interrupt" key is pressed. Only when more than 2 fixtures are placed can the product cycle processing be completed. Fully automatic processing can improve production efficiency. When the product on the first fixture is processed and the product on the second fixture is processed, the product on the first fixture can be replaced. When the product on the second fixture is processed, the product on the first fixture can be replaced to complete the reciprocating processing. If only one fixture is placed, only the semi-automatic processing mode can be used. In standby mode, press the number key "1" on the panel to enter the fully automatic working mode. When maintenance occurs, the entire machine stops moving. After repair, move the machine head to the highest position, use the "single step" key to find an empty position, and then press the "start" key to process. Otherwise, if you press the start key to process in the hole position that has been processed before, there will be a double hole phenomenon, which may damage the needle. You must pay attention when operating, and you should also pay attention when semi-automatic processing.
Semi-automatic
Press the "start" key once, process once, and after processing the product, the machine head stops at the highest position and works to the starting point. Replace the product, press the "start" key again, work to the first hole position, and process again. You can also start processing from the Nth hole to the last hole. N can be set. After entering the hole number on the keyboard, press the upper hole and lower hole keys to work to the hole to ensure that the hole position has not been processed. Press the "start" key to process, otherwise the needle will be damaged. When maintenance occurs, the handling method is the same as that of fully automatic processing.
Fully automatic type
After entering the product data, press the "upper hole" or "lower hole" button on the fully automatic test screen to complete the single-step hole alignment. You can check whether the hole position is correct. If it is wrong, you can exit and enter the experience correction interface to make corrections. After pressing Start, the workbench will move continuously until a product program file is completed, so that you can check whether the workbench is normal.
